Rev. 1.1 / May. 2013 31
AC & DC Input Measurement Levels
AC and DC Logic Input Levels for Single-Ended Signals
AC and DC Input Levels for Single-Ended Command and Address Signals
Notes:
1. For input only pins except RESET, Vref = VrefCA (DC).
2. Refer to "Overshoot and Undershoot Specifications" on page 44.
3. The ac peak noise on V
Ref
may not allow V
Ref
to deviate from V
RefCA(DC)
by more than +/-1% VDD (for refer-
ence: approx. +/- 13.5 mV).
4. For reference: approx. VDD/2 +/- 13.5 mV
5. These levels apply for 1.35 volt (see table above) operation only. If the device is operated at 1.5V (table "Single
Ended AC and DC Input Levels for DQ and DM" on page 32), the respective levels in JESD79-3 (VIH/L.CA(DC100),
VIH/L.CA(AC175), VIH/L.CA(AC150), VIH/L.CA(AC135), VIH/L.CA(AC125) etc.) apply. The 1.5V levels (VIH/
L.CA(DC100), VIH/L.CA(AC175), VIH/L.CA(AC150), VIH/L.CA(AC135), VIH/L.CA(AC125) etc.) do not apply when
the device is operated in the 1.35 voltage range.
Single Ended AC and DC Input Levels for Command and Address
Symbol Parameter
DDR3L-800/1066 DDR3L-1333/1600
Unit Notes
Min Max Min Max
VIH.CA(DC90) DC input logic high Vref + 0.09 VDD Vref + 0.09 VDD V 1
VIL.CA(DC90) DC input logic low VSS Vref - 0.09 VSS Vref - 0.09 V 1
VIH.CA(AC160) AC input logic high Vref + 0.160 Note2 Vref + 0.160 Note2 V 1,2,5
VIL.CA(AC160) AC input logic low Note2 Vref - 0.160 Note2 Vref - 0.160 V 1,2,5
VIH.CA(AC135) AC Input logic high Vref + 0.135 Note2 Vref + 0.135 Note2 V 1,2,5
VIL.CA(AC135) AC input logic low Note2 Vref - 0.135 Note2 Vref - 0.135 V 1,2,5
VIH.CA(AC125)AC Input logic high----V1,2,5
VIL.CA(AC125)AC input logic low----V1,2,5
V
RefCA(DC
)
Reference Voltage for
ADD, CMD inputs
0.49 * VDD 0.51 * VDD 0.49 * VDD 0.51 * VDD V 3,4
Comments to this Manuals